Z axis not homing correctly : r/ender3 r/ender3 r/ender3 • 5 min. ago Icy-Nerve3615 Join Z axis not homing correctly Help My x and y home just fine, but when it tries to home the y axis instead of going down to meet the limit switch it goes up and then everything resets to the position it was in before Vote Add a Comment Be the first to comment
Z axis not homing Ender 3 V2 with new 3DTouch Solved Hello I just installed a Triangle labs 3D touch on my ender 3 v2. I wired it to the BLTouch port on the board. I flashed a UBL 10x10 BLTouch version of Jyers Marlin specifically this version (E3V2-UBL-BLTouch-10x10-v4.2.2-v2..1.bin). My problem is, that the z axis is not homing correctly at the begin of the print. It goes down and triggers the micro switch, goes up and stays at the incorrect height during the print. This results in non sticking of the first layer. This problem only accoures one or two times in a day. The z-axis motor is not bound and is moving in both directions, just not after homing. I am also assuming the z-axis is supposed to be able to move down after homing, as the instruction for setting up the CRTouch specifically says to home the head, then to find the z-offset by lowering the z-axis. Plurrie Ender 3 V2 Z-axis homing VERY inconsistent Help Hi all, First time posting here, so hopefully I'm doing this right. My new stock Ender 3 V2 is having extreme deviations in Z-axis homing. When I auto-home, The nozzle will end up anywhere between perfect print height to a full millimeter off the bed, seemingly randomly. I got myself the Ender 3. The Home position is about 1 mm left and 2 mm in front of the front left corner. Now, the hotend center axis is 11 mm from the carrier plate with the "Mk 10" cooler mounted right onto a pair of 5 mm pegs that are part of the plate. As I want to change to an e3D v6, which has a diameter of 22 mm, I will have to move out SVDMBll.